Radiolink AT10II 12CH 2.4GHz RC Transmitter with R12DS Receiver

Reviews

1. J Jesus 5/5

   Works great for RC trucks

   I use this transmitter for my Tamiya RC trucks. It performs well and I’ve recommended it to friends so I can program their units for them.

2. M Monty G. 1/5

   Crashes after storage, firmware update didn't help

   It worked fine initially but after sitting unused it failed to boot one day. I tried updating the firmware and it didn’t fix the crash. Support was unresponsive, so I’m planning to move to another brand and replace several receivers.

3. Y yeti 5/5

   Exactly what I needed

   Matched my needs perfectly and the setup was quick and painless.

4. P Pascal 5/5

   Very good for helicopter use

   Both transmitter and receiver performed well on a helicopter with no signal loss during flights. Good overall value and reliable operation.

5. I Inducatvius 5/5

   My default transmitter

   I’ve been using it for a while now and haven’t had any problems.

6. J José Luis Nicolás Hernández 5/5

   Good starter unit for drone pilots

   Nice product for beginners with decent range. The sticks feel solid; precision is acceptable for learning and recreational flying. I use it primarily for drones.

7. T Travis Geis 3/5

   Serviceable radio but limited firmware

   The radio is easy to use, but it doesn’t run open-source firmware like openTX. The built-in software is simple and works, but mixing options are limited compared to open platforms (about four linear channels and two curve slots). It binds easily to Radiolink receivers and telemetry is reliable, even at very close ranges — handy for indoor models.

8. J Jack Hsieh 4/5

   Stable on the bench but battery connector worried me

   I compared signal timing on a scope and ran five high-current JR servos on the bench — the transmitter remained stable and servos didn’t interfere. I was impressed by the performance for the cost, but the two-pin battery connector has no latch and can pop out, which risks battery disconnect. A three-pin NiMH-style connector with a latch would be safer; I won’t use LiPo packs until I address the connector.

9. R Ronald I. 5/5

   Easy to set up and use

   Setup was straightforward and I haven’t encountered any negatives so far.

10. F Frank A-10 5/5

    Very intuitive, flew my Cub perfectly

    First time using it and setup was quick — binding was simple and I configured flaps and two switches without the manual. Flew my PA18 Cub multiple times with the included 12-channel R12DS and experienced excellent response. I’ve used high-end brands in the past but this unit impressed me enough to order two more receivers. Highly recommended for its ease of use, overall functionality and solid feel.

11. K ken 5/5

    Excellent reception and very smooth gimbals

    Reception matched or exceeded other systems during ground and long-range tests; I flew until the aircraft was out of sight and still had full bars. The screen shows signal strength and pack voltages in flight. Gimbals feel smoother than some competitors, setup is straightforward and the functions cover planes, multirotors and helis. Great for FPV with a low response latency.

12. J Jason Bouslaugh 5/5

    Solid alternative to other brands

    Better range than some competitors and lower cost than others. It performs well on both my drone and a plane, setup is simple, the LiPo input range is broad and elevon setup was the easiest I’ve used. Gimbals are impressively smooth in flight.